A minimum unit load of ___ volt-amperes shall be used to size feeder conductors for lighting and general use receptacle loads per square foot of floor area.

Receptacles located more than ___ feet above the floor are NOT required to be tamper resistant.

Receptacles located within ___ feet from the inside wall of a swimming pool must be protected by a Class A ground-fault circuit-interrupter.

Luminaires that weigh more than ___ pounds shall NOT be supported by the screw shell of a lampholder.

No. 14 copper conductors are permitted to have a maximum overcurrent protection device rating of many amps?

Cables not sleeved yet exposed to direct sunlight shall be listed and marked as “______”.

Receptacle outlets supplying bathrooms shall be provided with a minimum of _____ branch circuit(s).

Two grounding rods used in one grounding electrode system must be located at least ___ feet apart.

Bathrooms shall have at least one wall receptacle outlet installed within ___ inches of the outside edge of a lavatory basin.

An overhead service conductor spanning over a driveway shall maintain a minimum vertical clearance of ____ feet from final grade.